SAE J737 Hole Spacing for Scraper and Dozer Cutting Edges
作者:标准资料网 时间:2024-05-21 15:55:11 浏览:9452
来源:标准资料网
下载地址: 点击此处下载
Product Code:SAE J737
Title:Hole Spacing for Scraper and Dozer Cutting Edges
Issuing Committee:Mtc1, Loaders, Crawlers, Scrapers And Mounted Attachments
Scope:This standard is intended for cutting edge sections used on:a. Tractor-scrapers as described in SAE J1057 and J728b. Dozers as described in SAE J729. These cutting edges are further defined in SAE J738 for cross section and SAE J740 and J1580 for hole conformation. (Note: Some inch dimentions in this standard are not equivalent to the corresponding millimeter figures because values which are widely used have been adapted.This standard specifies hole placement along with length and width of the cutting edge.
Title:Hole Spacing for Scraper and Dozer Cutting Edges
Issuing Committee:Mtc1, Loaders, Crawlers, Scrapers And Mounted Attachments
Scope:This standard is intended for cutting edge sections used on:a. Tractor-scrapers as described in SAE J1057 and J728b. Dozers as described in SAE J729. These cutting edges are further defined in SAE J738 for cross section and SAE J740 and J1580 for hole conformation. (Note: Some inch dimentions in this standard are not equivalent to the corresponding millimeter figures because values which are widely used have been adapted.This standard specifies hole placement along with length and width of the cutting edge.
下载地址: 点击此处下载
